Check the blowing rod to see if the direction of the blowing hole on the blowing rod is correct, Labeling machine (the blowing hole must be blown toward the printer outlet and suction head at an oblique angle). Pass the label suction test to check whether the label is completely separated from the printer after the suction head sucks the label and before moving forward.
Make sure that the entire label has entered the suction head, especiallyIt's a small label, Labeling machine let alone a tail.
If the label has completely separated from the printer, but has not flattened into the suction head, Labeling machine check whether the suction head is flat and whether the label is receiving resistance on the suction head; if so, Labeling machine you need to treat the surface of the suction head. If the surface of the suction head is very flat, Labeling machine check whether the direction of the blowing hole on the blowing rod is appropriate.
If the label is not completely separated from the printer, Labeling machine and the label still has a little tail on the printer, the printer and printer software should be set up so that the printer is completed and the label paper is completely separated.Printer exit port.