What are the possible reasons for the six common failures of filling and capping machines? As the country has increasingly strict requirements on food quality and safety, food processing companies dare not ignore this. Among them, Filling machine the opening and sealing of bottles have become indispensable packaging links, Capping machine and strengthening food sealing packaging has also become a trend. In this regard, Capping machine the continuous innovation and progress of filling and capping machines provide strong equipment support for bottled food packaging.
When people buy filling and capping machines, they look to the big manufacturers and the quality of the products. The after-sales service of the filling and capping machine is also important. Here is an introduction to the common faults and repair methods of the filling and capping machine: The failure of automatic opening and stopping may be caused by the drift of the micro switch or the photoelectric switch. Remedy: Adjust the working position of the micro switch or photoelectric switch, Filling machine or replace with a new switch; there are two possible causes for the momentary over-current of the pneumatic motor, Filling machine one is the short circuit of the motor winding and the casing, Capping machine the second is the short circuit of the motor wiring and the grounding wire, Capping machine and the troubleshooting method is one check the motor and check whether the wiring is wired The switch is loose;Capping machine the overcurrent during acceleration may be caused by one. The acceleration time is set too short. Two. The motor capacity exceeds the inverter capacity. Elimination methods. One. Prolong the set time appropriately. Two.
Excessive voltage during operation may be caused by excessive changes in the power supply voltage. Elimination method. Power input test and add a reactor or appropriately reduce the supply voltage;Capping machine if the voltage is too low during operation, the power supply voltage may be too low or the same line often has large capacity equipment. Pneumatic elimination method 1.Improve the power quality 2.Use a power cord alone; Capping machine motor overload: possible cause 1.The load is too large 2.Is there a jam process on the machine 3.Improper setting troubleshooting method 1.Is the motor capacity suitable 2.Is the machine normal 3.The setting may be set Too small, Capping machine generally set according to the rated current of the motor