The filling machine mainly consists of three parts in structure: the storage tank, Filling machine the filling host and the frequency conversion speed control conveyor belt part.
Storage tank The storage tank is located on the upper part of the machine and is an atmospheric tank with a liquid level sensor and a feed solenoid valve. The material liquid sent from the previous process is put into the tank through the solenoid valve. When it reaches the appropriate liquid level, Filling machine the liquid level sensor sends a signal, Filling machine and the electrical control part controls the solenoid valve to close and stop feeding.
When the material level drops to a certain position When the time, Filling machine the feed solenoid valve can be opened to feed again. The lower part of the storage tank has a discharge port that is connected to the suction pipe of the filling host through a pipeline. When the host works, Filling machine the liquid in the storage tank is pumped into the piston cylinder, Filling machine and then filled into the bottle through the nozzle.
Filling host The filling host is the main device to complete the filling action. The front of the host is equipped with several filling heads, Filling machine and both sides are equipped with liquid pumping cylinders, Filling machine and each cylinder corresponds to a filling head. The liquid in the storage tank is pumped into the cylinder, then pressed out, Filling machine and filled into the corresponding bottle through the filling head.
There is a miniature cylinder on the filling head to drive a small piston to open and close the nozzle of the filling head, Filling machine acting as a valve. The entire filling head can rise and fall.