Label box: the center line of the label box, Labeling machine the center axis of the label station is tangent to the label paper, Labeling machine and the center axis of the label plate forms a line at three points. Adjust the tangency of the label plate and the label paper (0 distance), and then move the label box closer to 1mm~2mm.
Yes;Labeling machine the gap between the label paper in the label box and the pressing strips on both sides should be between 0.8mm-1mm, Labeling machine too large a gap will cause the label paper to shift in the label box, and there will be oblique marks.
If the gap is too small, it will cause poor label push;Labeling machine Adjustment of the position of the label grabbing hook: the upper and lower, left and right grabbing hooks are on the same vertical plane and evenly work hard on the label, then the label can be grasped smoothly; the adjustment of the label supply roller: when there is no label, Labeling machine the label pressing plate can press the label When the front end of the box is equipped with a label, the label near the label hook cannot be crushed.
Pressure brush device: the center of the standard brush is aligned with the label and the two sides are symmetrical; the standard brush is perpendicular to the surface of the container;Labeling machine the overlap gap of the pressure brush sweeping the container is: single pressure brush is 10mm~15mm, Labeling machine combined pressure brush is 5mm~10mm;The distance between the cleaning brush and the sponge is 1mm~2mm.