What are the possible reasons for the six common failures of filling and capping machines? As the country has increasingly strict requirements on food quality and safety, Capping machine food processing companies dare not ignore this. Among them, Capping machine the opening and sealing of bottles have become indispensable packaging links, Capping machine and strengthening food sealing packaging has also become a trend. In this regard, Capping machine the continuous innovation and progress of filling and capping machines provide strong equipment support for bottled food packaging.
When people buy filling and capping machines, they look to the big manufacturers and the quality of the products. The after-sales service of the filling and capping machine is also important. Let me introduce to you the common faults and repair methods of the filling and capping machine: the automatic opening and stopping failure may be caused by the drift of the micro switch or the photoelectric switch. Remedy: Adjust the working position of the micro switch or photoelectric switch, Capping machine or replace with a new switch. There are two possible reasons for the pneumatic transient overcurrent. One is the short circuit of the motor winding and the casing. The second is the short circuit of the motor wiring and the grounding wire. Close loose.
Possible causes of overcurrent during acceleration: 1. The acceleration time setting is too short 2. The motor capacity exceeds the inverter capacity. Elimination method 1. Prolong the setting time appropriately 2. The motor capacity cannot be changed at will; the voltage is too high during operation: the possible cause is that the power supply voltage has changed too much. Method Power input test to add a reactor or appropriately reduce the power supply voltage;Capping machine if the voltage is too low during operation, Capping machine it may be caused by the power supply voltage being too low or the same line often has large-capacity equipment pneumatics. The troubleshooting method is one to improve the quality of the power supply. load. Possible reasons: 1. The load is too large 2. Whether there is a jam process on the machine 3. The setting is improper. Solution 1. Whether the motor capacity is appropriate 2. Whether the machine is normal 3. The setting may be too small, Capping machine generally set according to the rated current of the motor.