After the production is over, Filling machine the following items need to be cleaned and maintained as soon as possible; clean up the negative pressure pipeline: After the production is completed, do not remove the upper splint, Filling machine unplug the negative pressure air tube from the vacuum negative pressure cup in the rear cabinet of the equipment, Filling machine and use alcohol or Hot water is injected into the negative pressure pipeline, and then blown against the pipeline with an air gun.
This requires 5 cycles: Clean the sealing device with an air gun, rag and water: remove the upper splint, Filling machine replace the cleaning pipe, and clean the lower splint with a water gun and an air gun: Clean the conveyor belt, Filling machine the machine table and the inner surface of the machine: close all doors, Filling machine you can perform CIP cleaning.
(Note: During CIP, do not open the door casually to prevent danger); Cleaning the upper splint: Use an air gun to blow out the moving parts of the upper splint, Filling machine and use a water gun and an air gun to clean the milk scale. Then put it in a safe and clean place; clean the negative pressure cup, blow dry and put it back in place; Filling machine clean the outer surface of the machine; clean up the waste; put the leftover material back in place; Filling machine fill in the complete production record; oil all lubrication points Lubrication (lubricated once a week)