Adjustment of the bottle inlet star wheel, Labeling machine bottle outlet star wheel, and bottle inlet screw rod: When adjusting the bottle inlet and outlet star wheel and bottle inlet screw rod, the press head of the standard machine shall prevail. First, Labeling machine adjust the bottle-in star wheel, when pressing the bottle head When just overwhelming the bottle, Labeling machine adjust the bottle inlet star wheel so that the bottle is in the middle of the star wheel groove.
Adjustment of the bottle feeding screw: take the bottle feeding star wheel as the standard, Labeling machine when the bottle is in the middle of the groove of the bottle feeding star wheel, adjustThe screw rod makes the bottle inlet side of the screw rod close to the bottle without displacement. Adjustment of the bottle-out star wheel: When the bottle pressing head is just raised, Labeling machine adjust the star wheel so that the bottle is in the middle of the groove of the star wheel.
The adjustment of the standard station: the adjustment of the squeegee and the squeegee: the squeegee and the squeegee must not have a gap in the entire length. If there is a gap, Labeling machine the squeegee can be adjusted by adjusting the eccentric bolt. Rubber roller and standard plateThe adjustment: the target plate and the rubber roller are only in contact with each other without any pressure. The gap is too large and there is too much glue on the target plate, Labeling machine
causing glue rejection. If the gap is too small and the contact is too tight, the glue will be squeezed away.
There is no glue on the side. Practice has proved that the gap between the standard plate and the rubber roller is between 0.1mm and 0.2mm. It can be achieved by adjusting the bearing seat at the lower part of the rubber roller adjust.